Franklin S - J Series Manuel d'utilisateur télécharger pdf

OWNER'S MANUAL

S - J Series Pump

Before Installation be sure to read all the

instructions and warnings carefully. Refer to the

product data plates for additional operating instruction

and speciﬁ cations.

INSPECTION

Examine the equipment when received. Notify your

dealer or carrier of any damage or missing parts. Verify

that the equipment is of size and model speciﬁ ed.

Meet National Electrical Code, Canadian Electrical

Code, and local codes for all wiring.

Follow wiring instructions in this manual when

connecting motor to power lines.

INSTALLATION LOCATION

All S & J Series pumps are designed for ﬂ ooded suction

(all suction ﬁ ttings and suction piping are below water

level) and will not self-prime.

READ AND FOLLOW SAFETY INSTRUCTIONS

This is the safety alert symbol. When you see

this symbol on your pump or in this manual, look

for one of the following signal words and be alert to the

potential for personal injury:

DANGER

warns about hazards that will cause

serious personal injury, death or major property damage

if ignored.

WARNING

warns about hazards that can cause

serious personal injury, death or major property damage

if ignored.

CAUTION

warns about hazards that will or can

cause minor personal injury or major property damage if

ignored.

The label NOTICE indicates special instructions, which

are important but not related to hazards.

Carefully read and follow all

safety instructions in this

manual and on pump.

Keep safety labels in good

condition.

Replace missing or damaged

safety labels.

Wire motor for correct

voltage. See “Electrical”

section of this manual and

motor nameplate.

Ground motor before

connecting to power supply.

Hazardous voltage.

Can shock, burn, or

cause death.

Ground pump before

connecting to power

supply. Disconnect

power before working

on pump, motor

or tank.

WARNING

1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - OWNER'S MANUAL

OWNER'S MANUALS - J Series PumpBefore Installation be sure to read all the instructions and warnings carefully. Refer to the product data plates

Page 2 - FOR THREADED CONNECTIONS

1GENERAL PLUMBINGFOR SOLVENT WELD CONNECTIONSRigid or ﬂ exible PVC pipe can be used. Pipe ends should be clean and free of any ﬂ ash caused by the cut

Page 3 - TROUBLESHOOTING

2TROUBLESHOOTINGMOTOR DOES NOT START1. Disconnect switch or circuit breaker in OFF position.2. Fuses blown or thermal overload open.3. Locked motor

Page 4

3PARTS FOR MODEL J, JCM, S, and SKM87a7365421Figure No. Part No. Description19010-1197-R Motor 3/4HP 115/1/60 48Y Frame9010-1247-R Motor 1HP 115/1/60

Page 5 - Franklin Pump Systems, Inc

4U.S. LIMITED WARRANTY*Franklin Pump Systems, Inc.Franklin Pump Systems, Inc. warrants its new products to be free of defects in material and workmans

Page 6

Page 7

Page 8